BobbyBarista one of the rubber tubes had developed a leak next to where the cable tie held it in place. I have attached a pic (x marks the spot) could anyone tell me where I can source a nee bit of tube by any chance
I think thats a flexible PTFE high pressure tube. Can you make a clear close-up photo of the hole. This is because a cable tie shouldn’t abrade it. I have a reason for asking.
I cant remember the OD and ID for the tube, could be 8 and 6mm. You want high quality flexible high Pressure PTFE tube good for 20 bar plus.
You might be able to use a Stanley life, and cut the tube with a nice clean 90 degree right angle cut, and then (if it’s long enough) you can simply reattach to the boiler fitting, by pressing it on hard all the way and then doing up the securing ring, it should flange itself onto the fitting.