Dazzer12 I have been around espresso for years, coupled with a very bad memory! I have had loads of machines, always prerring dual boilers for what appears to me to be obvious reasons. After a short spell away from espresso, I wanted to buy another machine. My last was a Lelit Elizabeth which is the cheapest machine that I have owned by a country mile. During ownership, I loved the way it heated up , ready to use in 15 minutes. You could turn the steam boiler on with the main boiler on and it was ready to go in 2 or 3 minutes. I knew Lelit were replacing the model anytime soon, so discounted rebuying. I would stress that I would have been perfectly happy with this model. Now the new one is out I am happy not to have waited around for it. Whlst I can appreciate all of its fine points, I detest that sort of thing.
So I bought the very unfashionable Sage Dual boiler having owned 6 I think before. Now I am quite aware that many people look down their noses at these. I would remind folks, that the features on a coffee machine rarely have much of an influence on the taste of the shot. Dual boiler, 3 minutes heat up time. One of the very interesting things is that no matter how long the machine is on the group does not heat up so that you cannot touch it. Instead it is the internals that heat the pf and by using a bottomless you actually aid the shot as it is much easier to heat up. SO my question is, if Sage can think of and do this, why does nearly every other machine rely on the group heating up so much that you cannot start it?
Dazzer12, the more you look around the more complicated you are making things. Draw up a list of the 3 things you absolutely need as opposed to desire. Believe me, a Profitec does not make a better shot than a GS3......you are the barista! The last variation of the Liz was a mature machine. It had been out in the wild for years and all known faults were known and dealt with. I suspect if you looked into it with Sage as I did, you will learn that your Oracle Jet group is not meant to heat up! Below is an excert from a Sage support email.
Thank you for contacting Sage Support, we appreciate having this opportunity to assist you.
We understand that you were expecting the group head to become much hotter, to the point where it would be uncomfortable to touch.
We sincerely apologize for any inconvenience and disappointment you may have experienced. Please rest assured that we are dedicated to supporting you and finding the best possible solution.
To address your concern and clarify that the machine is not designed for the group head to become extremely hot to the touch.
The group head you checked earlier is made of stainless steel and does not contain a heating sync/ element inside it. Instead, it is warmed indirectly by the hot water flowing through the brewing system. Because of this design, the group head may feel warm rather than very hot, which is normal and does not indicate a fault with the machine.
Rest assured, as long as the machine is reaching the correct brewing temperature and producing hot water properly, it is operating as intended.