Hi All (especially DaveC if you are around)
Dave, thanks for the excellent Lelit Elizabeth Quick Reference Guide. Well done!
I implemented the suggested advanced settings and perhaps I did something wrong. When I turn on the machine, the pump and water now runs constantly. I see the Lelit logo on the display, but it does not even go to OK or show any temps. And none of the buttons on the left light up.
I tried to reset by turning on the machine and holding minus at the same time, but this does not solve the problem. I then again went into the advanced program and re-entered your advanced settings. This did not correct the issue.
Any sense of what I did wrong? This problem only emerged when I changed the advanced settings.
Should I do a complete reset to factory settings, for the entire machine? If so, how? If I could just get back to where I was before.
Any other ideas?
I’d be most grateful for your help today, as the vendor that sold me the machine (just last week) is closed today. Moreover I would be surprised if this was a mechanical issue, firmware or software flaw, as this problem only emerged when I changed the advanced settings. We can converse through this board. Or we can FaceTime or Zoom or whatever, if you are willing to do so. I do not wish to impose at all. Any help with this will be gratefully received.
JHCCoffee (Julian, from Canada).