LMSC How easy is that swap from pressure stat to pressure sensor. I guess, the firmware also needs to be flashed.
Shouldn’t be too hard, although the thread for the pressure sensor looks a little larger, so you need an adaptor. You also need to ensure you have the height available, as the sensor is a tiny bit larger and the adaptor “may” take up space, unless there is an existing adaptor for the ¼ inch one you can take off.
Plus you will need to remove the display to flash it with a USB key, whilst leaving it connected to the machine and powered. When you replace it, you would do well to add a ribbon cable to the side port, so would would never have to remove it again.
Pressure sensor won’t be cheap either.
