It’s loosened up a bit but struggling to get it out - will keep hammering away

Niche Zero

Niche Zero

    DavecUK might have to take this somewhere to try get it sorted - it’s loosened up to point where I can turn it with fingers, but only moving ever so slightly back and forward.
    Is it normally quite hard to remove it?

    Niche Zero

    Niche Zero

        Ando I’m confused, you should be able to remove it with a spanner easily now….video please showing exactly what’s moving backwards and forwards. Because you don’t want to pay £80-100 for a 5 minute job.

        Contact me

            There wasn’t anything obvious scale wise - the part has been cleaned, replaced and same problem (see video). The small top piece that you press on to remove the hose doesn’t feel right, almost a bit flimsy

            Niche Zero

            Niche Zero

              I should add - this leaking happens when it’s heating up. It stops once up to temp.

              Niche Zero

              Niche Zero

              2 months later

              Same problem on mine - part is MC935F Quick Joint

              This forum is an inspiration. First leakage issues, and no panic. I imagined a @DavecUK character standing next to me and asking what investigations I had done, with a reassuring voice asking me to show the inside of the machine, that the leak should be pretty obvious. Top off, spot the issue almost immediately. Quick read of forum and find similar issue, identify part… Part is in stock at local retailer, off there tomorrow morning.

                jcb1973 Nice one! Once new part was put in it resolved the problem, machine running well again.
                Agree re forum being very helpful!

                Niche Zero

                Niche Zero

                  Same - a very quick fix. All working again!