Sworks one off shower screen for ACS

LMSC What’s your tamper size please?

Afaik 54.7 but will check.

On a night out tonight

Too big for the acs basket, which i did know. Had been using a 54.4 for that and that was a sloppy fit in the ims comp basket.

Bravo is a good fit for the ims. Feels same as the 54.4 did in the acs.

Need to investigate but i feel the taper on the ims is slightly more than the acs as well . Mainly because at first glance when I store the puck screen in the basket its the same fit in the bottom of the basket as it has been in the acs basket….

Only had 4 cups so far but seems good.

Nothing ground breaking but i can see i dont have to concentrate any more whilst tamping!!!

dfk41 well, I can certainly see the meditation is working, Dave. :D

This was originally a commissioned product, sought after by someone who wasn’t happy with the stock clip and screen (who am I to argue with them for that?). Now it’s being offered to others who may want it, perhaps for similar reasons, perhaps for others.

It is fairly obvious the price excludes die-hard skeptics, leaving those with disposable income or a purpose they can justify to themselves - could be that some people care about the stock screen and spring not fitting well enough for good wetting of the puck - I’ve had nasty lop-sided extractions occur in that situation, and I don’t enjoy messing around with the circlip (something Jake also mentioned). I’d like it to experiment with it, and will happily run with it if it makes my life a bit easier on the maintenance front.

Cuprajake No, the safety sleeve was a bit more consistent for me (in that regard - fitting with shower screen, but its distribution has issues due to a single off-center hole and no distribution block). Since you and a few others had issues with the hole being too far off-center, ACS likely ensured the hole was drilled to land within the blank perimeter of the shower screen.

I noticed the stock GU10 spring and shower screen combo doesn’t always sit square in the stock sleeve, and had noticed some extractions were biased on one side of the basket. Subsequently, went over to the circlip Adrian linked, and have a lot more consistency overall, but can’t say I enjoy resintalling that circlip when I decide it’s time for a clean and a quick lube of the accessible portion of the sleeve.