ACS Vesuvius Evo Leva

Cuprajake

I presume cost re the rotary pump there not cheap

I understand your reasoning with the pre infusion,

I’ve never plumbed a machine in for fear of bad water going into my machine

Abdulaziz

Cuprajake well, I don’t direct connect my machine to house plumbing. I use RO system in the kitchen to filter and control my TH and TDS and use this water to fill a tank under my bar. After that i have a system using the tank with a bwt bestmax filter to feed machine and a tap for my kettle 👌🏽 It is not a fancy setup my it does the job perfectly

Cuprajake

That’s perfect

Cuprajake

Back on the North star Brazilian

DavecUK

Cuprajake Looked perfect…are you sure you got enough crema 😉

CoyoteOldMan

Cuprajake That custom camera stand is at the right angle for sure. Nice shot!

Cuprajake

It’s been a learning curve, but getting more consistent. I’m still amazed at, a the sweetness it’s bringing out and b, the consistency, I’ve not sinked a single shot yet

And to boot, when making tea tonight, risotto I went looking for peas, and found frozen coffee 😂😂

LMSC

Cuprajake

Giphy -

CoyoteOldMan

With a fruity taste… 🤣

MediumRoastSteam

Hmmm …. Coffee Risotto…Masterchef next Jake? 🤣🤣🤣🤣🤣🤣

Cuprajake

hi,

im at work and want to bring a tool home to take the side panels off are they just the allen key? or bolts

cheers

LMSC

Cuprajake Allen keys

Cuprajake

Cheers guys, I presen

CoyoteOldMan

You’ve gone all white…

How long did it take for you to get the panels from order?

Cuprajake

Yeah looks good doesn’t it

These are wrapped in satin vinyl.

I was tempted to paint them but wanted to see first.

DavecUK

Looks really good!

CoyoteOldMan

It definitely does look good, and very much the same colour as the paint (at least in photo). Only concern I would have with vinyl film is how long it’s going to be before it bubbles (especially with heat beneath it).

Cuprajake

Yeah, totally agree

It’s just a tester to see if it looked good, I’m a painter by trade so, now I know it looks ok I’ll probably paint the panels in a 2k satin White(ral)

It’s usually signal white

hysaf

I went the same route around Xmas and vinyl wrapped the sides with a white marble vinyl that I had available, just to see how it looks in white. Regret not taking any pictures, because it really looked interesting but only kept for a few hours before I took it off.
Also I was thinking of Palstidip as a non permanent solution for playing with colours.

hysaf

Just posted mine for sale.
Im torn between a rock and a hard place cause Im not using it as much as I want, but then I start reading peoples experiences and get excited all over again.

this springs to mind this scene

LMSC

hysaf Not an easy decision if you aren’t using much. How many cups of coffee do you drink? Most of us go to work and grab a cup in the morning. Evening is uncertain. I won’t sell under these circumstances, unless the counter space is a problem or other unexpected reasons. The last thing you need is sell it off and regret the sale. I remember one of the Evo owners planning a sale for reasons of space, but didn’t in the end.

We hope you have thought about this sufficiently.

« Previous Page Next Page »