Dual Boiler Machines

Thanks, will give this a go again tonight. Perhaps I didn’t drain enough the last time. If this doesn’t work I found the article below which suggests I can drain the boiler from the vacuum breaker usi...

Thank you for that. I think that I have understood the advanced bit but must read it again carefully. Regarding the ‘advanced LCC Settings’ just to clarify a couple of things, can I know if the ‘steam...

I’ve heard Wera is god tier. If the Bosch hex bit aren’t great, I’ll upgrade.

Dismantle the lower part of the group and give it a good clean.

My Lelit Elizabeth worked for a couple of years with no steam leaks, but for the last year or so I’ve had a bit of steam continuing to leak from the steam wand after its turned off, which was annoying...

Thank you all so much for the help!. I pulled the refill sensor out and cleaned it. I also noticed the plastic sleeve was not allowing any real exposure of the probe to the water so I ended up cutting...

Thanks both- so i did indeed turn off low flow for my first port of call just after posting this :). That being said, if its programable to a set time., i would assume it “knows” to set a low flow reg...

Machine Sold

Just a quick update—I ended up ordering an Osmio Zero. The unit was shipped the same day I placed the order and arrived the following day, which was a pleasant surprise since next-day shipping wasn’t ...

Who knows, only Gicar and they ain’t talking?

thanks just found it.

Based on the guage it’s just over 2 bar which is inline with the recommendations from the instructions 2-3 bar and the flow is pretty good as whilst we have had it unplugged we have been using it (wit...

I have a contact in Wales who is happy to take a look for me. He specialises in QM machines and can source parts from Italy. Just need to get off my arse and send down to him

Oh that is interesting. So if you push the outer fitting it will release the tube? I wondered about that when I worked on it because I could not figure out how to release the tube.

It helps when you contact someone who did the top level design for the MK1.

Open the machine when you can and you should be able to point out where it comes from easily. And yes… that rubber gasket! 🤣🤣🤣🤣🤣🤣

Yes it was!!! So stupid!!! Thank you so much!

I’ve been following this thread since I was having the same issue with pressure overshoot during my shots with my Elizabeth. For me, it was happening on every shot so I decided to open the machine and...

Sorry, I have no idea. But then again… Without videos or photos it’s hard to picture what the problem really is.

To be honest, i didn’t notice anything unusual apart from the HW LED flashing. Pretty sure the other (1 and 2) lights were not on (which they are when standby mode is enabled). also, it didn’t happen ...