This from Sheldon (Sworksdesign.com) on the Decent Diaspora forum:
Sheldon Wong sworksdesign.com
On this current iteration - from perfectly clean inside, it ate about 0.5-0.6g on the first dose. I use a Mr. Puff regardless of the burr set and see about the same amount coming out but I donāt feel RPM is an issue. I have no idea about longevity of the gearset though - gear reduction and motor torque seems sufficient so far.
Alignment is what I want to focus (what little time I have) on to understand the stiffness of the whole assembly and what is achievable without shimming.
What will worry me is tolerances between grinders - I wonder if Niche will tell me what their designed tolerances are š¤