- Edited
Not for re-cutting drill bits in a hand drill which you clamp and then turn the handle to rotate the drill bit?
Not for re-cutting drill bits in a hand drill which you clamp and then turn the handle to rotate the drill bit?
Elcarajillo I assumed the jaws were flat as if to hold sheet metal…do they have a semicircular section on each jaw, so a round object can be held within them but still rotate?
Pompeyexile Getting very warm👍
DavecUK one with 90 deg V the other flat.
I know I said cutting drill bits but more precisely sharpening them? or re-sizing them?
Pompeyexile sorry not drills and not sharpening .
Chuffin hell! You said I was warm before when I mentioned a drill!
Now where’s the cat?… I need to kick something. (joke)
De burring something ?
Waitforme something like that
Pompeyexile something in your statement was very warm😀
Elcarajillo something in your statement was very warm😀
Are you a stripper in your spare time because you are a bit of a tease.
Cutting a thread to make a bolt or machine screw
Lelit Elizabeth, Niche Zero
V60 with Drip Assist, Clever Dripper, Knock Feld47
Aeropress, Knock Aergrind
No bolts or screw threads😔
Pompeyexile At my age😂. Analyse/ disect your statement= important word
My head hurts! There had better be a chuffin prize after all this!
I’ve got it!!!!! It’s obvious!
It’s for taking the rough edges off a 90’s pop singer…….it’s a…..wait for it….wait fror it….
Chris De-Burr……..broooooom tish!
Is it for cutting metal rods? Or thin metal pipe - like brake pipes?
Pompeyexile I think you should go and indulge in some coffee= you are obviously stressssssed
Consult the coffee flow chart on funnies thread, read and inwardly ingest👍😁