Vesuvius Pressure Profiling Machine - General Discussion

JahLaza

It’s not a spare. Count the turns on the ones you have against my picture and ensure the correct springs are used. The “spare” is from the un-mod’d preinfusion chamber.

Thanks folks, I quickly realised that when I tried it out at temp/pressure. The other spring back in now. It does seem like the spring is the cause of the stiff lever action for venting though? I might look for a replacement… Any thoughts on the excessive water discharge issue?

JahLaza

If you disassemble again please post a picture of all of the parts laid out as you will reassemble them in the orientation you intend to reassemble.

Also confirm the cam is correct and you fitted the cam lever first then the top and bottom chambers.

I’m still thinking assembly issue, sorry as it really can’t be wrong if it’s clean and moly on all springs and surfaces for assembly.

Adrianmsmith ok will do tomorrow morning thanks again

Adrianmsmith Hi, I disassembled again, here’s some pics, orientation as I disassembled and reassembled. molycote everywhere, all along spindle, all around cam, all around valves where they meet anything else, put back together again, cam first, top barrel, bottom barrel, lever, and it’s still stiff. The only time it hasn’t been stiff is when I changed that spring!

JahLaza Where exactly are you putting this and where did it come from?

DavecUK Hi Dave, that sits in the bottom barrel, as per my previous post to @Adrianmsmith just now, I had thought that was causing an issue due to my lack of knowledge but it obviously wasn’t, so, that went back in as it had come out, sitting down snug into the bottom barrel. I had never removed that before yesterday, so it’s not causing any issue

Also note the orientation of this piece, compared to yours.

Did you have the machine from new?

DavecUK Also note the orientation of this piece

Omg I’m starting to cuss myself now!! Yes that piece is incorrectly orientated in my pic, but I have it sitting correctly in reality, and it has been sitting the correct way all along - the fatter/wider side to the bottom sitting into the barrel. Yes I have the machine from new - march 2022. The other piece you ask about as specified by @Adrianmsmith is a metal piece with a couple of drilled holes in the bottom section

JahLaza This piece is wrong orientation

Adrianmsmith This piece is wrong orientation

I took a few photos to try show everything as clearly as possible that’s the best I could get. The narrower side of that piece is on the bottom, the narrower side of it is sitting down into the barrel, the wider, flange side on top, is that correct? I’m aware that the preinfusion spring is absent on the Vesuvius by design

JahLaza The piece circled in green should be the other way up

Adrianmsmith Thanks, yes it is/was/has been the other way round but for some insane reason unbeknownst to me I turned it that way for the picture! I was speaking about the bottom most metal piece in the picture in my last post where I asked about its orientation. I thought you said it was the wrong way?

JahLaza the bottom bit, flat side to the spring.

looks like unside down hat!

Adrianmsmith yes all assembled as it should. Sorry again for that one wrong display, I’m stumped as to the issue